Contact us: +39 - 0438 - 45 08 60 - Email: info@erone.com

The installer’s choice

CDVI PASS

CDVI PASS

Product reference: 
-

CDVI Pass is based on an active tag equipped with a radio double technology, passive (at 125 KHz) and active (at 433,92 MHz).  The active tag stays always in stand-by: when it arrives inside the aerial detection zone, it wakes-up and starts transmitting at 433,93 MHz.  In this way its battery consumption is highly limited. If, whilst remaining in the detection zone, it  does not move, the internal motion sensor sets it in stand-by. The wake-up signal at 125 KHz carries even a byte with the serial number of the antenna (1-99). Once awake, and as long as it stands in the field at 125 KHz, the tag transmits an encrypted signal with its serial number and the serial number of the antenna. The receiver decrypts the signal and extracts this information. If the output set is wiegand or RS-485, the information is sent on the wiegand bus or RS-485 line otherwise if the output is “relay” the receiver activates the relay (1 or 2) if the S/N of the tag has been authorized. In this case the receiver can drive directly a automatic closure system (gate, road barrier, door, etc..)

 

ReferenceDescription
KCPKIT CDVI PASS ( ANTENNA + RECEIVER + 2 ACTIVE TAGS)
AN01CPANTENNA TRIGGER CDVI PASS W/FIXING BRACKET
AN02CPANTENNA TRIGGER CDVI PASS LOW RANGE
ATCPACTIVE TAG CDVI PASS
RXCPRECEIVER CDVI PASS
MBCPBACKUP MEMORY CDVI PASS
SEA433TUNED ANTENNA 433 MHz

CDVI Pass is a radio system for the access control of persons and vehicles. It is mainly composed by 3 devices: one active tag, one trigger antenna and one receiver. It finds application in domestic, pubblic, residential and industrial environment, both for personal and vehicular use. The users or the vehicles carrying the active card and standing in the detection zone of the trigger aerial, are identified waking-up the tag, which is normally in stand-by and deconding the tag information. The serial number of the tag, that identifies uniquely the user, is then transmitted via radio to the receiver which, at its turn, sends the information to any access control system, through a RS-485 or wiegand line.
 

Other products from the category 'CDVI PASS'

CDVI Wireless SpA, born in 1996, makes part of CDVI Group since 2005. It develops and manufactures analog and digital wireless electronic devices. ERONE by CDVI Wireless, is the commercial brand which identifies the wireless products of the CDVI Group.

Contact

Cdvi Wireless SpA
Via Piave n° 23
31020 San Pietro di Feletto, Treviso ( Italy )
Tel: +39 - 0438 - 45 08 60
Fax: +39 - 0438 - 45 56 28
E-mail: info@erone.com
Web: www.erone.com

Back to Top